Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation.
Remove and Replace LR TPMS Sensor
SPARK PLUGS – Remove & Replace – Gas
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – FWD, Gas Front Axle, Right Side – [Includes: Confirm Fluid temperature for level check.] – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists
Remove and Replace Left Low Beam Headlight
Gil S. gave our service a 5 star review on 7/22/2026
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [Includes: Calibration.] – [DOES NOT include disassemble or alignment.]
RADIATOR HOSE – Remove & Replace – Both
Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation.
(Combination) AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Left Side – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
Test drive vehicle. Set up to measure alignment specs. on all four wheels and adjust front toe angle
Bob N. gave our service a 5 star review on 7/16/2026